Voltammetric Behavior of Arsenic(III) in the Presence of Sodium Diethyl Dithiocarbamate and Its Determination in Water and Highly Saline Samples by Adsorptive Stripping Voltammetry

This paper describes the voltammetric behavior of As(III) at the hanging mercury drop electrode (HMDE) in the presence of sodium diethyl dithiocarbamate (SDDC) and a new voltammetric method for the determination of As(III) at trace levels. The method is based on the adsorptive deposition of a As(III) complex with SDDC at ?0.45 V (vs. Ag/AgCl) on the HMDE in acidic medium of 0.01 mol L^?1 HCl (pH 2.0) and its cathodic stripping during the potential scan (100 mV s^?1). The linear range for the determination of As(III) in the presence of SDDC (4 μmol L^?1) in water samples was between 1 and 10 μg L^?1 for a deposition time of 300 s (r=0.994) and between 10 and 100 μg L^?1 for a deposition time of 60 s (r=0.999). For the determination of As(III) in dialysis concentrate samples, the linear range was between 5 and 25 μg L^?1 for a deposition time of 180 s (r=0.992) and between 10 and 100 μg L^?1 for a deposition time of 60 s (r=0.996). Detection limits of 0.3 and 2.2 μg L^?1 in water and dialysis concentrate samples were calculated for the method using a deposition time of 300 and 180 s, respectively. Recovery values between 93.0 and 110.0% for As(III) added to deionized, mineral, seawater (synthetic and real) and dialysis concentrate samples prove the satisfactory accuracy and applicability of the procedure.     

Erosion of efficiency in non-uniform linear chromatography

In linear chromatography (i.e. chromatography performed in the absence of sample overloading), when the plate height of a column is roughly uniform along its length, variations in the velocities of solutes are the only possible causes of erosion of efficiency. The sources of these variations (variations in capacity ratio and in the density of the mobile phase, etc.) play no direct role in the erosion of efficiency except through their effect on solute velocities. In other words, what eventually causes the erosion of efficiency is merely variation in the time required for solutes to traverse equally small segments of a column. Significant erosion can only arise from abrupt and deep deceleration of solutes in one or several relatively small segments of a column. If erosion of efficiency caused by pressure gradients in linear SFC is to be large, the depth and the sharpness of the deceleration of a solute must go beyond that hitherto confirmed experimentally. Many relevant examples are analyzed graphically.     

Determination of Azidothymidine – an Antiproliferative and Virostatic Drug by Square‐Wave Voltammetry

The 3′‐azido‐3′‐deoxythymidine (AZT, Zidovudine) is an antiproliferative and virostatic drug widely used in human immunodeficiency virus type 1 (HIV‐1) infection treatment. With respect to side effects of high doses and a short half‐life of AZT, a fast and simple detection method for this agent could be helpful. The aim of our study was to determine AZT levels in natural samples (urine, serum, whole blood, and cell cultures, such as the HaCaT line of keratinocytes) without their mineralization and/or purification, by means of electrochemical methods using hanging mercury drop electrode (HMDE). On this electrode, AZT undergoes irreversible reduction at the peak potential near E_p?1.1 V (vs. Ag/AgCl/3 M KCl). Reduction AZT signals were measured by cyclic voltammetry (CV), differential pulse voltammetry (DPV), square‐wave voltammetry (SWV), and constant current chronopotentiometric stripping analysis (CPSA). In phosphate buffer (pH 8) the SWV yielded the best AZT signal with the detection limit of 1 nM. The determination of AZT concentration in biological materials is affected by electroactive components, such as proteins and DNA. For monitoring the influence of these compounds, AZT reduction was performed in the presence of 10 μg/mL calf thymus ssDNA and/or 100 μg/mL bovine serum albumin. In these cases, the detection limit increased to 0.25 μM. Also studied was the AZT concentration in keratinocyte cells (HaCaT line) during cell cultivation. It has been shown that the SWV may be considered as a useful tool for the determination of AZT concentration in cell cultures, and for monitoring AZT pharmacokinetics.     

An algorithm for the calculation of the electrostatic repulsion between surface coated with a charge membrane

We propose a numerical procedure for the calculation of the electrostatic repulsion force between two identical, parallel surfaces immersed in anab electrolyte solution. These surfaces are coated with an ion-penetrable membrane carrying fixed charges. The amount of fixed charges is governed by the dissociation of the functional groups in the membrane phase. The effect of pH on the degree of dissociation of these functional groups is taken into account. The difficulty of extensive use of Jacobi elliptic function in the numerical treatment of Poisson-Boltzmann equation can be circumvented by resorting to the present algorithm.     

A predictive model for impact response of viscoelastic polymers in drop tests

We show for the first time that a classical Hookean viscoelastic constitutive law for rubbery materials can predict the impact forces and deflections measured with a commercial drop tester when a mass, or tup with a flat impacting surface is dropped onto a flat pad of commercial impact-absorbing rubber. The viscoelastic properties of the rubber, namely the relaxation times and strengths, are obtained by a standard rheological linear-oscillatory test, and the equation of momentum transfer is then solved, using these measured parameters, assuming a uniaxial deflection of the pad during the impact. Good agreement between measured and predicted forces and deflections is obtained for a series of various drop heights, tup masses, impact areas, and pad thicknesses, as long as the deflection of the pad relative to its thickness is small or modest (<50% or so), and as long as the area of the pad is less than or equal to that of the tup. When the pad area is greater than the tup, forces are higher than predicted, unless an empirical factor is introduced to account for the nonuniaxial stretching of the ring of material that extends outside of the impact area. These results imply that the impact-absorbing properties of a rubbery polymeric material can be assessed by simply examining the material's linear viscoelastic spectrum.     

气相二茂铁双电荷离子的动能谱研究

The unimolecular charge separation reactions of the doubly charged ions FeC_(10)H_(10)~(2+)、FeC_(10)H_9~(2+)、FeC_(10)H_8~(2+) produced in the ion source by electron impact from ferrocene have been studied using Mass analyzed Ion Kinetic Energy Spectrometry (MIKES) technique. From the values of the kinetic energy releases (T), the intercharge distances (R) of the exploding doubly charged ions in their transition structures have been estimated and some structural informations about the transition states can be obtained. The collision induced reactions of the FeC_(10)H_(10)~(2+) ion with Ar have been studied using MIKES, we postulate a new type of continuing reaction which may be "collisional charge separation induced dissociation".     

Chiral separations by capillary electromigration techniques in nonaqueous media. I. Enantioselective nonaqueous capillary electrophoresis

Enantiomer separations by CE employing nonaqueous conditions are reviewed. The general focus of this article is directed towards solvent effects on chiral recognition and the separation mechanism. After a general discussion of solvent effects on the individual processes involved in CE enantiomer separation, specifics for various selector classes are discussed together with a few applications of enantioselective nonaqueous CE.     

Interaction of the mutagen ethidium bromide with DNA, using a carbon paste electrode and a hanging mercury drop electrode

The interaction of ethidium bromide (2,7-diamino-10-ethyl-9-phenylphenanthridinium bromide; EB) with double stranded (ds) calf thymus DNA and thermally denatured single stranded (ss) DNA was studied in solution and at the electrode surface by means of transfer voltammetry using a carbon paste electrode (CPE) as working electrode in 0.2 M acetate buffer, pH 5.0. As a result of intercalation of this dye between the base pairs of dsDNA, the characteristic peak of dsDNA, due to the oxidation of guanine residues, decreased and after a particular concentration of EB a new peak at +0.81 V appeared, probably due to the formation of a complex between dsDNA and EB. The non-intercalated EB gives another peak, but at an increased concentration of the dye. A similar behaviour was observed during the interaction of the dye with ssDNA.Furthermore, the interaction of EB with ds, ss and supercoiled (sc) DNA was studied at the hanging mercury drop electrode (HMDE) surface by means of alternating current voltammetry in 0.3 M NaCl and 50 mM sodium phosphate buffer (pH 8.5) as supporting electrolyte. dsDNA yields a smaller peak at −1.42 V (peak III) compared to the one yielded by ssDNA, since the latter is a relaxed and more accessible form. By addition of EB into the buffer solution an increase of peak III was observed in the dsDNA form as well as in ssDNA resulting from their interaction with EB. Furthermore, the appearance of peak III in covalently closed circular scDNA after exposure to increasing concentrations of EB is a result of the introduction of ‘free ends’ in DNA affecting its structural integrity.     

Determination of TNT and its metabolites in water samples by voltammetric techniques

Square-wave voltammetry with the hanging drop mercury electrode as the working electrode was used for the determination of ultratraces of explosives in aqueous solution. It was shown that the strong pressure dependence of the pneumatically controlled multimode electrode system of a conventional Metrohm apparatus could be compensated by an additional pressure regulation, through which the pressure variations could be decreased when switching from deaeration to the static measurements. By using square-wave voltammetry with this electrode system after this modification the limits of detection for 2,4,6-trinitrotoluene (TNT) and other TNT-metabolites could be decreased down to 0.2 μg L⁻¹ when using a measurement time of 6 min. Also a simultaneous determination of TNT and hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) was shown to be possible over a wide linear range and the detection limits then were 2.2 μg L⁻¹ for TNT and 25 μg L⁻¹ for RDX. By applying the highly stable and adjustable pressure as mentioned before, the calibrations could be kept stable over a period of up to 1 week.